Adams Driveshaft and Off Road

ADAMS FORGED FORD 8.8 1350 SERIES U-BOLT STYLE DIFFERENTIAL PINION YOKE WITH UP TO 30 DEGREES OF ANGLE.

If you have or are getting ready to install a Ford 8.8 Rear Differential in your Offroad Vehicle, then this yoke is a must. This 8.8 Yoke gives you up to 30 degrees depending on how thick your slip yoke is and the Factory Flange only gives you 22 degrees. This yoke has more Angle than any other Yoke on the Market so it can handle more Articulation in Offroad Applications.

This Rear Pinion yoke is the Strongest on the Market and will allow you to install a 1350 Series Driveshaft to the Rear of your Jeep, Etc.

Benefits of this Yoke over Others: 

Adams Manufacture's this Forged Yoke in the U.S.A.

U-joint Cap area is Machined to Support the cap all the way around.

The U-joint Cap Retainer/Tab goes half way around the yoke unlike most yokes with 3/8" around.

Strongest 8.8 Pinion Yoke on the Market.

Shipped via FED-EX 2nd Day in all 50 States at no Extra Cost.

This Item will come with the Following Parts:

[1] Forged 8.8 1350 Series Rear Pinion Yoke [Rubicon Only].

[1] Set of 1350 Series U-bolts that are made in the U.S.A.

[1] Packet of Red Threadlocker.

CA Residents:  WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov

This is a Link from our Website Explaining how to set your Angles and some Issues with using the Factory Ford 8.8 Pinion Flange instead of a Traditional Pinion Yoke. 

8.8 Tech Info